Author Topic: oil pressure sender thread size?  (Read 1376 times)

penfold1981

  • 170BHP Member
  • ***
  • Posts: 131
    • View Profile
oil pressure sender thread size?
« on: 17:06, Wed 23 September 2009 »
does anyone know the thread size of the oil pressure sender?

I'm going to fit a capillary oil pressure gauge and need to know what size adaptor I need to attach it where the original sender fits.

Hope that makes sense :-)

I know CGB sell one but I'm getting a Stack gauge from Demon Tweeks and wanted to buy the lot from there.

James5

  • Test
  • Global Moderator
  • 200BHP Senior Member
  • *****
  • Posts: 2772
    • View Profile
(No subject)
« Reply #1 on: 20:02, Wed 23 September 2009 »
I think it's -6 JIC matey

penfold1981

  • 170BHP Member
  • ***
  • Posts: 131
    • View Profile
(No subject)
« Reply #2 on: 17:18, Fri 25 September 2009 »
never heard of JIC before but good old google came up with a conversion chart :-)

Thanks dude

James5

  • Test
  • Global Moderator
  • 200BHP Senior Member
  • *****
  • Posts: 2772
    • View Profile
(No subject)
« Reply #3 on: 21:56, Fri 25 September 2009 »
I use one of these just before where the braided oil feed would attach but after the 1 way valve
http://www.speedflowshop.co.uk/-6-coupl ... -241-p.asp
I use a mechanical mocal pressure gauge with braided feed cable