Author Topic: torque settings  (Read 1479 times)

davesgtt,s

  • 200BHP Senior Member
  • ****
  • Posts: 204
    • View Profile
torque settings
« on: 15:30, Tue 28 April 2009 »
torque settings for k-tek head bolts,need to know a.s.a.p please

like right now if any of you lot know it......

DanielSon-gtt

  • 200BHP Senior Member
  • ****
  • Posts: 970
    • View Profile
(No subject)
« Reply #1 on: 15:32, Tue 28 April 2009 »
is that the high tensile ones yea its 60-80nm anythink less than 80 needs a retourq after 200miles and 80 doesnt
Go Boost Or Go Home

davesgtt,s

  • 200BHP Senior Member
  • ****
  • Posts: 204
    • View Profile
(No subject)
« Reply #2 on: 15:34, Tue 28 April 2009 »
spot on mate,ill go and borrow my naighbers torque wrench and get it done.

thanks dan

DanielSon-gtt

  • 200BHP Senior Member
  • ****
  • Posts: 970
    • View Profile
(No subject)
« Reply #3 on: 15:39, Tue 28 April 2009 »
no worries mate
Go Boost Or Go Home

James5

  • Global Moderator
  • 200BHP Senior Member
  • *****
  • Posts: 2772
    • View Profile
    • http://www.rtoc.org/boards/member.php?u=34
(No subject)
« Reply #4 on: 17:49, Tue 28 April 2009 »
You could check out the DIY section matey.
But yeah 12.9 headbolts and a blue seal H/G do to 80nm and no need to re-torque tappets may require adjustment again though