Author Topic: I got bored... hope this helps someone!  (Read 2320 times)

H18_1T_G0

  • 150BHP Member
  • **
  • Posts: 21
    • View Profile
I got bored... hope this helps someone!
« on: 00:30, Thu 29 January 2009 »
as said in title, i got bored, made this pic with MS paint.

this is supposed to be a diagram of my mates engine bay with the cup mod...

thought it might help someone in the future maybe?

note i done this with paint so pipes going over pipes etc that should be underneath them but you get the idea...



 :D

jure

  • 200BHP Senior Member
  • ****
  • Posts: 1465
    • View Profile
    • http://www.renault-klub.hr
(No subject)
« Reply #1 on: 07:05, Thu 29 January 2009 »
Top job mate. Saved in my archive  8)

sonic-jdm

  • 200BHP Senior Member
  • ****
  • Posts: 179
    • View Profile
(No subject)
« Reply #2 on: 13:53, Thu 29 January 2009 »
Good effort mate :o

H18_1T_G0

  • 150BHP Member
  • **
  • Posts: 21
    • View Profile
(No subject)
« Reply #3 on: 21:34, Thu 29 January 2009 »
lol sweet, if any of the pipes are wrong atall let me know.. i done this off the top of my head and im sure one or 2 of them water pipes T into eachother before they reach the pump... but close enough!

i know its in the right place lol!  :P

r5gtt08

  • 200BHP Senior Member
  • ****
  • Posts: 706
    • View Profile
(No subject)
« Reply #4 on: 22:02, Thu 29 January 2009 »
good diagram m8y  :lol:  :wink:

must ov took you ages to do that lol :shock:
DONT KNOCK IT TIL YOU TRIED IT!!!!!!!!!

H18_1T_G0

  • 150BHP Member
  • **
  • Posts: 21
    • View Profile
(No subject)
« Reply #5 on: 22:06, Thu 29 January 2009 »
hour or so lol, paint!

sonic-jdm

  • 200BHP Senior Member
  • ****
  • Posts: 179
    • View Profile
(No subject)
« Reply #6 on: 11:32, Fri 30 January 2009 »
Can you do one for the engine wireing loom now :lol:

H18_1T_G0

  • 150BHP Member
  • **
  • Posts: 21
    • View Profile
(No subject)
« Reply #7 on: 00:49, Sat 31 January 2009 »
lol if i knew how they went myself i would, but half of the wiring on my mates one is not bieng used and it was already a chopped n changed loom, instead of the original plugs there are spade connectors, and i got a wire from the main Batt- alternator live going to the Rad fan switch via a fairly thick wire, then to the fan cuz all the relay and connectors were nackerd etc...

but yeh the reason i done it is because i have been going by the haynes manual with this one, and i just wanted to make something that people can actually understand!

if i work the wiring out i will do one!