Author Topic: hose sizes/diameter??  (Read 1161 times)

dgdogz

  • 200BHP Senior Member
  • ****
  • Posts: 447
    • View Profile
hose sizes/diameter??
« on: 11:15, Mon 19 May 2008 »
hi dose anybody know straight off the size/ diameter of pipe from induction kit to the turbo

my viper kit is on a 90 degree bend facing the wing
so its a really tight bend
i want to move it up so the feed for the viper is point straight to the grill
i think ill need a couple 180 bends or something but im not sure ofthe sizes
my cars parked at a mates garage and its a nytmare to get too plus im at work
so if anybody knows then tht would be a greattttttttttt help


cheers lads

Ash-Lee

  • Global Moderator
  • 200BHP Senior Member
  • *****
  • Posts: 4208
    • View Profile
(No subject)
« Reply #1 on: 13:20, Mon 19 May 2008 »
Theres limited space under the bonnet, especially when it comes to trying to fit the air filter.

I've got a Green cotton filter and i have just cut the original telephone hose in half which is a 90 degree bend but it places it right behind the intercooler so i get good airflow passing through that.

Much better then having it run by the side of the turbo.

dgdogz

  • 200BHP Senior Member
  • ****
  • Posts: 447
    • View Profile
(No subject)
« Reply #2 on: 13:43, Mon 19 May 2008 »
i know
its really cramped...im gona move it to just next to the header tank were the diaphragm pump is...then have the feed runnin strait to the grill.
i was just looking for the pipe size so i can order them today
an cause im not near the car i cant get it off to measure

cheers man