Author Topic: B18ft wiring (not mine a mates this time)  (Read 2832 times)

sparkysparks

  • 200BHP Senior Member
  • ****
  • Posts: 967
    • View Profile
B18ft wiring (not mine a mates this time)
« on: 22:03, Tue 25 June 2013 »
We have changed the head gasket and cant remember how the wiring was done.
The Crank Position Sensor has an extra wire, which we labelled (not connected),
The ignition plug has 3 wires, one is cut short and one is cut and was connected, but should that be the one on the CPS?

Also his indicators are on constantly, we dont know why.

Any help on this would be appreciated.

Mark

sparkysparks

  • 200BHP Senior Member
  • ****
  • Posts: 967
    • View Profile
Re: B18ft wiring (not mine a mates this time)
« Reply #1 on: 21:11, Mon 16 September 2013 »
Ok, making progress, i think the 3rd wire on the crank position switch is infact an earth.
The battery in the remote is dead and i we think that the alarm is in a constant state of imobilised.
Were still not getting spark.

Compression was 13 75 130 130 after head gasket change, but were putting that down to that its been sat for a while.

Any help on this guys, its getting cold now, we need this running.  Cheers