Author Topic: Engine fitting any special tools needed  (Read 1801 times)

Rupx

  • 150BHP Member
  • **
  • Posts: 30
    • View Profile
Engine fitting any special tools needed
« on: 20:27, Thu 07 July 2011 »
Pretty open question ,but would you say fitting a engine in 5 is pretty staight forward and are any special tools required. Built many a mx bike engine but never a car, so do i attempt it myslef or take it off to some guys i have used in the past , with a rolling road too.
If anyones wants to offer their services i'm more than willing to pay. Not picked the car up yet or found donor engine, but planning ahead  8)  8)  8)

Big Steve Raider

  • 170BHP Member
  • ***
  • Posts: 121
    • View Profile
    • http://s306.photobucket.com/albums/nn259/BigSteveT/Raider/
Re: Engine fitting any special tools needed
« Reply #1 on: 20:54, Thu 07 July 2011 »
Just an engine crane, Socket set Hammer & Punches & you're laughing  :wink:

Rupx

  • 150BHP Member
  • **
  • Posts: 30
    • View Profile
Re: Engine fitting any special tools needed
« Reply #2 on: 21:11, Thu 07 July 2011 »
As long as i can get it to run i'l get it set up after  :wink: