Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - linni

Pages: [1]
Links / possible bargain ph1 look!
« on: 13:01, Tue 25 October 2011 »
just stumbled across this! leccy blue phase one for 900 quid :o might be worth giving him a ring  :lol:

General Chat / one for the carb tinkerers
« on: 22:31, Tue 31 May 2011 »
just remembered about these used to use them for fine tuning 2stroke bikes could be useful to some of you?

Renault 5 GT Turbo / carb base manifold pipework
« on: 22:34, Thu 17 February 2011 »
can anyone tell me where the above are routed to and also the 2 ports in a v shape on the drivers side of the carb

Renault 5 GT Turbo / header tank as catch tank?
« on: 17:20, Wed 09 February 2011 »
after abit of over enthusiastic bidding on t'old fleabay i have ended up with two alloy header tanks for the 5
just wandering if the spare could be put to good use as a catch tank or something
ifnot itll be up for swaps as i need a chrome carb top rocker cover or a front mount got the 5

Renault 5 GT Turbo / bolt in elbow? :S
« on: 00:31, Tue 08 February 2011 »
picked up another t2 recently as my oil seals were f****d the new turbo also came with an elbow but it has a bolt in the rear where the metal pipe usually bolts into just wandering why this has been done?

got a shed load of hoses to replace the ones missing on my 5 just wondering if anybody had diagrams or a list knocking about for which hoses go where as its totally baffling me
also im looking to tidy up the bay asmuch as possible so if theres any mods i can do to remove pipework id be very grateful to know
i need diagrams or point to points for
the carb the inlet manifold the water pump swirl pot and breather pot

Renault 5 GT Turbo / which hoses ?
« on: 14:43, Sun 14 November 2010 »
right guys just need a little help with hoses as the maze is doing my nut in
1.where do the hohses from the back of the inlet manifold go to?
2. hose from waterpump (just infront of the temp sensor on waterpump)
3.what pipe connects to the valve which runs from the actuator pipework ?
cheers guys

Renault 5 GT Turbo / hi tensile bolt size?
« on: 12:18, Fri 12 November 2010 »
hi guys just wandering if anybody knows what size socket/hex key ill need to fit the hi tensile bolts from cgb on my 5 as im doing my h/g tomorrow

General Chat / jesus christ!
« on: 10:56, Wed 06 October 2010 »
feast your eyes on this beast boys! ... 2c57aee775

seriously though whoever owns this needs to punch theirself in the nuts several times!

dont laugh too hard please im creasing so bad i can feel a 6pack coming on  :lol:

Renault 5 GT Turbo / clio 16v bonnet vent?
« on: 14:05, Tue 03 August 2010 »
fancy a clio valver bonnet vent on my 5 was just wandering whats the best way to go about doing it? is the clio bonnet a straight swap or would it be a cut and weld jobby as i really dont wana go sticking bits of fiberglass to my 5 :lol:

Non Renault topics / 306 engine conversion
« on: 14:43, Sat 20 March 2010 »
right my mates recently bought a 306
its a 1.4 8v but hes been offered a 2.0 16v xsi from another 306
just wondering how difficult hthe conversion is and also whats needed
getting everything with the engine inc engine loom and ecu
should be a pretty simple swap shouldnt it?
anyone done this conversion or something similar?

General Chat / one for the diy'ers
« on: 20:59, Wed 03 February 2010 »
found this

thought it might be of some use to some of those who like to do things themselves  :twisted:


Renault 5 GT Turbo / chatter!
« on: 20:15, Mon 25 January 2010 »
thinking about getting rid of the dumpvalve on my 5 as its tatty and leaking
plus the fact that chatter is 100 times better than any dumpvalve hah!
just wondering how to go about doing it and what to do with the vaccum hose thats connected to the dv?
cheers in advance
linni :twisted:

Renault 5 GT Turbo / door pins?
« on: 01:22, Sat 12 December 2009 »
has anybody had the pleasure of having to do the door pins on their 5 if so isit difficult/ faffy?
just asking because my n/s door had dropped pretty bad and needs a fair slam to get it shut.need doing as i dont want anybody pushing it trying to latch it and leaving a handprint in my door haha  :shock:

Newbies / hi all
« on: 23:46, Sun 06 December 2009 »
alright people my names linni and as of today im the proud owner of this little beast :)

only had this car a few hours and i love it already  :wink:
im from west yorks so if anyones local give me a shout  8)

Pages: [1]