Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BNZ

Pages: [1] 2 3 ... 12
1
Renault 5 GT Turbo / Re: volvo turbo conversion info please
« on: 12:11, Thu 03 September 2009 »
Quote from: "sparkysparks"
Hi guys, whats involved, i know its a straight engine swap with a gtx engine mount.
Do you use the same gearbox.
Do you need the wiring loom and ecu's
Do you need the fuel tank and exhaust for recirc purposes.
What turbos fit on them.
Any help appreciated
Mark


Same gearbox
Of Curse you need the loom and the ecu's
Dowpipe fits perfect to the R5.From the cat down you can trow everithing away
As for the Fuel tank you cant take it and swap it,obviously,so you'll end up with fuel starvation on an near-empty tank,during acceleration.Therefore the solution is a SurgeTank
Turbo's => Saab T25

2
Renault 5 GT Turbo /
« on: 12:04, Thu 03 September 2009 »
The balance of the car will go in the bucket ! You will need some custom designed springs for the heavier nose,if you plan to race the car !
As for the mounts,that's true,you will need some additional mounts build on top between the strut bar (if you have one) and the engine to stop it from moving forward or backwards.Inertia will rip apart the stock rubber !

3
Renault 5 GT Turbo /
« on: 14:34, Tue 06 January 2009 »
chatter = turbo cry !
not good at all !

4
Your cars /
« on: 16:59, Mon 17 November 2008 »
Quote from: "R5energy"
What suspension do you have on your car (front and rear)? Are this (front axel) KW coilovers?


Spax RSX




5
Your cars /
« on: 17:28, Tue 21 October 2008 »
Big Brake Conversion Kit (K-tec)



6
Your cars /
« on: 23:58, Sun 13 July 2008 »
HillClimb Straja 2008
Place 1 Class 2000-3000cmc





7
Your cars /
« on: 19:53, Wed 09 July 2008 »
HillClimb Resita 2008 - Forelighter


8
Your cars /
« on: 23:15, Tue 01 July 2008 »

9
Your cars /
« on: 09:49, Mon 30 June 2008 »
HilClimb Surduc 2008 - Pro's
Place 2 class 2000-3000 cmc (H14)




10
Your cars /
« on: 07:10, Fri 30 May 2008 »

11
Your cars /
« on: 07:09, Fri 30 May 2008 »
GP Buzias 2008 - 4th Place



 .  .  
   .  .

12
Renault 5 GT Turbo /
« on: 08:41, Thu 22 May 2008 »
Willwood has some 4 pot calipers for GTT

13
Renault 5 GT Turbo /
« on: 00:41, Thu 08 May 2008 »
it is possible,2 friends of mine have done it !
U have to lift the engine with a jack,take the chain off,release every rod from the head,and then the trick is to use a magnet,or bether 8 magnets,the small one used to retrive the nuts from small places,and hold the cups up,so when u take the cam out,they wont fall down in the engine block !

14
Your cars /
« on: 17:45, Mon 21 April 2008 »
Sannicolau Mare - Circuit

Place I at Class,Place III la OPEN (just 0.01s slower than a Subaru Impreza STI) !!!




15
Your cars /
« on: 12:44, Fri 18 April 2008 »

Pages: [1] 2 3 ... 12