Author Topic: re using head gasket  (Read 601 times)

owe

  • 200BHP Senior Member
  • ****
  • Posts: 493
    • View Profile
re using head gasket
« on: 14:43, Sun 31 March 2013 »
hi, just bolted my head down and realised the valve stem seals have popped off again, even after i super glued them on last time lol. could i get away with unbolting the head and re use the gasket? it hasnt been run
everybody needs to watch this film >>>>>endgame by alex jones

Ash-Lee

  • Global Moderator
  • 200BHP Senior Member
  • *****
  • Posts: 4208
    • View Profile
Re: re using head gasket
« Reply #1 on: 20:21, Sun 31 March 2013 »
I've done it before and it worked out ok, I've also not been bothered about the valve stem seals which never seem to stay seated and that worked out ok also.  :lol:

owe

  • 200BHP Senior Member
  • ****
  • Posts: 493
    • View Profile
Re: re using head gasket
« Reply #2 on: 22:39, Sun 31 March 2013 »
nice one ash. ye im still debating it, i think i might just try and get them back on through the springs with the rocker shaft off. i'll try sticking them with aroldite this time lol.
everybody needs to watch this film >>>>>endgame by alex jones