Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 5teve L

Pages: [1] 2 3 ... 5
1
General Chat / Spammers taken over the site
« on: 19:13, Fri 16 December 2016 »
Nobody uses this site except spammed,  the site owner has gone awol & us mods gave up trying to clear all the spammed long ago.. sorry everyone

2
General Chat / Members locations
« on: 08:39, Sat 26 January 2013 »
You can post here the general location you live so maybe you can arrange meets, or convoys to events.
We did have another but I deleted it by accident  :oops:   :lol:


Steve L --- West Sussex UK

3
General Chat / Merry Christmas everyone :)
« on: 11:08, Mon 24 December 2012 »





4
General Chat / James5
« on: 20:39, Thu 25 August 2011 »
Any of you not on RTOC, James wrote his car off this morning, he is fine with just a few bruises, from the sounds of it he is VERY lucky to be with us. He lost the car & rolled or flipped it a couple of times before coming to a rest on the roof  :shock:
He seemed to think it was a total loss as front & rear were gone plus most of the glass & the sidey went.   :cry:
After all that hassle  :(

Hope you get things sorted matey.

5
General Chat / What shall I do ?
« on: 18:33, Wed 22 June 2011 »
I'm going to run a little poll to see what others think as I'm a little stuck.
Do I persevere & finish the Raider, drop the turbo lump into the 19 or sell the 19 as it's near mint & could be a good standard car..
Let's see what people think..
The 5 will prob be fine when I put the new head on as I reckon it was the lifters..
The 19 is wider & not many turbo ones in the UK...
Both retro &  8)

7
Do it yourself / F7P conversion..
« on: 17:46, Sat 29 January 2011 »
Wiring pin outs, whats needed etc.

Complete engine & wiring loom inc the aux fuse box from a phase 1 as the ecu isn't coded. You should end up with a brown & white plug.  If you are taking the gearbox you need the clocks as well as they are cable driven & the GTT is electronic pick up.
You will need a GTX mount for the block, these are NLA from Renault so more than likely you will need to modify the GTT one, I will add pictures at a later date of my modified mount.
Manifold & downpipe will be needed as well unless you are going turbo  :twisted: .

Here is a diagram of the F7P engine loom pin outs.
http://s70.photobucket.com/albums/i96/2 ... rpage1.jpg

Also from another member the ecu pin outs
http://forum.4tuning.ro/attachment.php?attachmentid=761440&d=1232458541
http://forum.4tuning.ro/attachment.php?attachmentid=761527&d=1232464210


Some of the GTT pin outs I have identified so far.

R5 GTT loom plug

A1 alt reg (Yellow) thick
A5 reverse lamp (W)
A6 reverse lamp (Yellow)
A7 Starter sol (W) thick
B2 oil level (O)
B3 oil pressure (O)
B-4 oil level (brown)
B6 oil pressure (brown)
B7 alt reg (Purple)

--------------------------------------------------------------------------------

OK, for anyone using the R19 phase 1 wiring this is what I have so far, admittedly I still need to check it all works  but will update.

R19 brown plug --------------------- R5 engine loom
C7 ---------------------------------------------A1
D4--------------------------------------------- A5
D6--------------------------------------------- A6
D7 ---------------------------------------------A7
B5--------------------------------------------- B2
B-4--------------------------------------------- B-4
C2 ---------------------------------------------B3
B7 ---------------------------------------------B6
D3 ---------------------------------------------B7

----------------------------------------R5 plug behind ashtray (just tap in with cable clamps)
C1 ---------------------------------------------B1
B1 ---------------------------------------------B7
B6--------------------------------------------- C1

Fuel pump wiring, the plug that is by the drivers footwell kick plate is the one that you need to find & use B7 (white).
A7 ---------------------------------------------B7  
I actually cut the white GTT fuel pump relay wire & used that to feed the pump from the loom.

Still to look for this but apparently there is a black two pin plug under the dash somewhere, one wire is constant live, the other ign/switched
A6 + D1 Live feed + pin 6 ecu --------------------------Pin 1
C7 Switched ign feed+ pin 9 ecu----------------------Pin 2

Earth------------------ pin 2 ecu

Apparently the other plug (refered to the white plug for the clio loom conversion) isn't used at all on the R19 phase 1 wiring,  I need to check if any clio ecu works at all.

Here is the clio wiring diagram

Clio 16v loom---------------------------------------R5 loom
C7 ---------------------------------------------A1
D4--------------------------------------------- A5
D6--------------------------------------------- A6
D7 ---------------------------------------------A7
B5--------------------------------------------- B2
B-4--------------------------------------------- B-4
C2 ---------------------------------------------B3
B7 ---------------------------------------------B6
D3 ---------------------------------------------B7

----------------------------------------R5 plug behind ashtray (just tap in with cable clamps)
C1 ---------------------------------------------B1
B1 ---------------------------------------------B7
B6--------------------------------------------- C1

smaller white plug B-4------------- B7 drivers footwell (fuel pump)

I actually cut the white GTT fuel pump relay wire & used that to feed the pump from the loom.


Still to look for this but apparently there is a black two pin plug under the dash somewhere, one wire is constant live, the other ign/switched

Main plug B2 & D1/White plug A3 & A7 + pin 6 ecu------------------ Constant live
Main plug A1 & C7 + pin 9 ecu  ----------------------------------------------Switched live

Earth-----------------------Pin 2 ecu

I will test this & update it works.

Oil drain for turbo conversion.

Hole drilled

1/2" NPT Tap

Oil drain fitted in place.


How it will look fitted


8
Events/Shows/Cruises / Outlaw Street FWD shootout 21/8/11
« on: 09:56, Tue 25 January 2011 »
The Date and Venue have now been announced for the first UK Outlaw Street FWD Shootout

Sunday 21 Aug 2011 at Santapod

We are looking to organise an Outlaw Street FWD shootout, they are massive in the US and with the number of fast FWD cars in the uk increasing yearly now seems like a good time to pull them all together in on location, for one weekend only

We are still in the planning stages at the moment, but please show your interest by following us on facebook

UK Outlaw Street FWD Shootout


10
Media / Rainbow gear
« on: 19:06, Sat 18 December 2010 »

11
General Chat / Happy Bday James5
« on: 09:45, Mon 22 November 2010 »
Have a good one mate, I know Lauren has allowed you to play with the car so enjoy :)

12
Events/Shows/Cruises / Surrey meet.
« on: 14:17, Sun 29 August 2010 »
Following on from a good meet we had round Phils last week he has now sorted a venue we can all meet up in Surrey, here are the details from RTOC.

--------------------------------------------------------------------------------

ok all i have now got confirmation and the dates and times for the surrey meet it will be on the first wednesday of every month and will start from 7pm onwards the steward will lay on some nibbles for us lot as they dont sell food there i have set it up on this date as it will fall every 2 weeks between ace cafe meet so every 2 weeks we all have a chance to meet as i know not everyone can make ace cafe but will make this meet and vice versa

a bit short notice but i am going to start it from the 1st of september 2010 and from then on it will be the first wednesday of every month

this is the post code of the meet incase you need directions KT20 6SZ it does not have a door number but it is known as the kinswood villiage social club it is situated right on the main road of the A217 about 1 mile from junction 8 on the M25

i have put a list of names here of people that have all ready said they are up for it please add your name to the list if i have left you off i really wanna make another good meet will be great to see lots of old and new faces

many thanks phil

Be good to see some of you if you can make it & just add your name to the list.

philr5t
mike phase 1 16v
dave..h
steve L
James5 (Henfield)  
clint (clintorous)
john jrp jerpa jerpa
The new bill j
stu21t
schwartz
markey mark
wallace
car.crash not in a 5 being gay
rat1 in a 5
gtTnutter
bong john
Logg in a 5
wide 5

13
Your cars / My Raider... now F7P project...
« on: 14:25, Sat 21 August 2010 »
Thought I'd post up a small spec sheet for the new WIP>

Fairly standard at the mo but here is a brief run down.
T28
FMIC
2 1/4 exhaust
Samco water hoses
poly bushed arb
lowered 50mm
standard speedlines painted black.

Plans are 285 cam, more boost & some 195/45/13 tyres for the standard rims.
I plan on leaving the car as standard looking as poss.

14
General Chat / I'm back !!
« on: 21:34, Sun 15 August 2010 »
Yep, bought myself another GT Turbo tonight, Raider this time.... will post piccies up when I sort the niggles out on her :)

15
Your cars / The S3
« on: 18:03, Mon 17 May 2010 »
Just a quick post about the new car.
99 Audi S3 Quattro, metallic black with black half leather with grey alacantra, standard & staying that way for a little while at least  :twisted: .
Only mods I've done are braided brake lines & some new discs on the front.
It's a nippy little car & handles pretty well for standard IMO, got to get the rear arch done as it's just starting to blister, 175 to sort it..
pics to follow

Pages: [1] 2 3 ... 5